气相色谱法测定二硫化碳和甲硫醚

利用气相色谱(配火焰光度检测器,采用3mxφ2mm玻璃填充柱分离)对CS2和甲硫醚(DMS)两种含硫化合物进行了分离检测。该方法具有较高的灵敏度和良好的线性关系。结果表明:该分析对含硫气体的最小检测浓度在mg/m3级,在柱温为70℃,检测器温度为180℃,气化室温度为150℃,氮气流速为50mL/min时,CS2的回收率为98.66%,变异系数为2.12%;甲硫醚的回收率为98.66%,变异系数为1.56%。     

脉冲电晕等离子体脱硫脱氮与除尘技术

脉冲电晕放电是产生等离子体的方法之一，目前已达到工业性试验阶段，该文对脉冲电晕等离子脱硫脱氮与除尘技术的形成过程进行了回顾，对其理论作了分析，并简介了工艺流程，还指出了目前存在的主要问题和需研究的关键技术。     

Developing Canada's National Forest Carbon Monitoring, Accounting and Reporting System to Meet the Reporting Requirements of the Kyoto Protocol

The rate of carbon accumulation in the atmosphere can be reduced by decreasing emissions from the burning of fossil fuels and by increasing the net uptake (or reducing the net loss) of carbon in terrestrial (and aquatic) ecosystems. The Kyoto Protocol addresses both the release and uptake of carbon. Canada is developing a National Forest Carbon Monitoring, Accounting and Reporting System in support of its international obligations to report greenhouse gas sources and sinks. This system employs forest-inventory data, growth and yield information, and statistics on natural disturbances, management actions and land-use change to estimate forest carbon stocks, changes in carbon stocks, and emissions of non-CO₂ greenhouse gases. A key component of the system is the Carbon Budget Model of the Canadian Forest Sector (CBM-CFS). The model is undergoing extensive revisions to enable analyses at four spatial scales (national, provincial, forest management unit and stand) and in annual time steps. The model and the supporting databases can be used to assess carbon-stock changes between 1990 and the present, and to predict future carbon-stock changes based on scenarios of future disturbance rates and management actions.     

Carbon Dioxide Balance of Wood Substitution: Comparing Concrete- and Wood-Framed Buildings

In this study a method is suggested to compare the net carbon dioxide (CO₂) emission from the construction of concrete- and wood-framed buildings. The method is then applied to two buildings in Sweden and Finland constructed with wood frames, compared with functionally equivalent buildings constructed with concrete frames. Carbon accounting includes: emissions due to fossil fuel use in the production of building materials; the replacement of fossil fuels by biomass residues from logging, wood processing, construction and demolition; carbon stock changes in forests and buildings; and cement process reactions. The results show that wood-framed construction requires less energy, and emits less CO₂ to the atmosphere, than concrete-framed construction. The lifecycle emission difference between the wood- and concrete-framed buildings ranges from 30 to 130 kg C per m² of floor area. Hence, a net reduction of CO₂ emission can be obtained by increasing the proportion of wood-based building materials, relative to concrete materials. The benefits would be greatest if the biomass residues resulting from the production of the wood building materials were fully used in energy supply systems. The carbon mitigation efficiency, expressed in terms of biomass used per unit of reduced carbon emission, is considerably better if the wood is used to replace concrete building material than if the wood is used directly as biofuel.     

氨法烟气脱硫脱硝的技术特征

氨法烟气脱硫脱硝具有显著的技术优势:脱硫效率高,脱硫脱硝一举两得,不耗费热量不产生废渣,脱硫剂利用充分用量小,不损害设备有节能功效。脱硫剂利用率可达90%以上,脱硫效率可达90%以上、脱硝效率可达80%以上;脱硫剂用量是钙法工艺的十到二十分之一;副产物为可以直接利用的化学肥料,而非难于处置的废渣。     

楚雄德胜钢铁公司烧结机尾除尘改造实践

介绍楚雄德胜钢铁公司19·6m2烧结机尾除尘系统改造工程中使用三电极电除尘器的工艺及有关设计技术问题,并根据使用效果进行分析总结。结果表明,在设计参数选择恰当的情况下,三电极电除尘器对烧结烟气有较好的除尘效果,这些经验和操作中存在的问题供烧结机尾除尘工程设计参考。     

城市生活垃圾热解产气特性的试验研究

在外热式固定床试验台上,针对城市生活垃圾中的典型组分,进行了不同条件下的热解试验研究。试验测量不同条件下产物的产气量和产气速率,分析了热解气的组分和气体热值。分析发现,物料的挥发分、加热方式以及热解终温等对产气影响大,随温度的增加产气中H2含量逐渐增多,C2H4和C2H6的含量逐渐下降,气体热值有一个最大值。     

一起瓦斯事故后的思考

介绍了峰峰集团公司小屯矿14443回采工作面基本情况和瓦斯事故发生及处理经过,分析了事故原因,针对该事故从5个方面提出值得思考的问题.     

乙烯废碱液综合治理技术探讨

分析了乙烯裂解气碱洗过程所排放废液的组成及性质，讨论了该废液的除油方法及综合治理和利用的途径。     

甲硫醚废气制取二甲基亚砜技术研究

选择双氧水作氧化剂，将具有恶臭气味的涕灭威生产的副产物甲硫醚氧化成无臭的二甲基亚砜。通过实验，优化了工艺条件，减少了安全隐患，提高了二甲基亚砜的产率，消除了恶臭污染。